I'm posting this blog because it took me a while to find the correct codes to program this VFD with, so hopefully by putting all of the information in one spot someone else will have an easier go of it.

This is the VFD that came with a 2x72 Belt Grinder bought on Ebay (from Remmer-4513). In the end, the codes that worked for me were:

-PD002: 1

-PD003: 60

-PD004: 60

-PD005: 60

-PD070: 1

-PD072: 60

I wanted the belt grinder to be foot pedal controlled and have an on/off switch, so I wired in series a foot-pedal and on/off switch between the FOR and DCM pins.

I made this plaque to commemorate Steve Buda and the tools bought with donations made in his memory. 

1. I bought brass sheet from Goody's Hardware in East Haven
   1. It was a kick plate for a door
   2. Not brass plated, but solid brass
2. I bought CRC Moly Dry Lube from Napa Auto for ~$20
3. I cleaned the brass with rubbing alcohol, rubbed it with steel wool for a bit, and then cleaned it again.
4. In the fume hood I sprayed the brass with the lube. I gave it 3 coats, with about an hour in between each coat.
5. I used the Universal Laser 60W CO2 with air assist, set to 100% Power, 0.9% Speed and