Casting Pot (C.A. Technologies)

Primary tabs

Status: 
Requirements for Use
Required Badges: 

Pressure Casting

Watch Video
Pass Quiz
Facilitator Checkout

Check Out With Facilitator

Community Facilitators are volunteers who to advise MakeHaven members on projects and show members how to use the tools.

Facilitator hours will be BY APPOINTMENT during their listed hours. To make an appointment, contact the facilitator directly via Slack. To prevent unnecessary space access during the pandemic, facilitators will not be in the space unless they have an appointment. Note that some facilitators are available only for online virtual appointments at this time. Any questions please email info@makehaven.org.

Community Facilitators are volunteers who to advise MakeHaven members on projects and show members how to use the tools.



Member Photo Next Scheduled Hours

Julia Murphy

Casting & Plastics, Mold Making


Wednesday Mar 3, 6:00pm to 9:00pm

Jen Fremd

Woodworking


Sunday Mar 7, 3:30pm to 6:30pm

Instructions for Use: 
1. Maximum tank pressure of 80 psi. The safety relief valve is designed to protect the tank against excessive pressures. DO NOT
attempt to make adjustments to this valve. If this valve begins to vent air, reduce the setting on the air inlet regulator.
2. DO NOT alter the tank in any way by welding, drilling or machining as this may weaken the structure of the tank.
3. To prevent hazardous static sparks from occurring, always ground the tank by connecting a 12 ga. wire to the tank and to a
known earth ground.
4. Be sure tank pressure is completely relieved before attempting to remove tank cover or material fill cap. Shut off the main air
supply to the tank and vent pressure using the vent valve located on the tank lid
Area of Interest: 
Digital Fabrication